Openwork Chippendale Drawer Pull in 3 Sizes

Our Openwork Chippendale Drawer pull's back plate is made of stamped brass and the bail is made of solid cast brass.   This pull is available in three sizes.

DP-182: The back plate is 2-3/4"wide by 2"high and mounts using two holes that measure 2" from the center of one hole to the center of the other or has 2" centers.

DP-183:  The back plate is 3-3/8"wide by 2-3/8"high and mounts using two holes that measure 2-1/2" from the center of one hole to the center of the other or has 2-1/2" centers.

DP-184:  The back plate is 4-1/16"wide by 2-7/8"high and mounts using two holes that measure 3" from the center of one hole to the center of the other or has 3" centers.

Made of  brass, these pieces put the final touches on your restoration or refinishing project.  A hallmark of this period of furnishings is to use different size pulls on higher and lower drawers on the same piece.  Please remember to check the distance between the two mounting holes on each drawer to ensure that your hardware fits properly. 

Do you have a piece of furniture from the Bicentennial era?  Chippendale hardware was commonly used on furniture made during that period.